Sears GT Series Installation Instructions Manual page 8

7. Remove and retain remaining bracket by removing (2)
screws. See Fig. 12.
8. Remove the blower assembly by sliding it forward. See
Fig. 13,
NOTE: Unit top is notched to allow blower to slide through.
9. Remove and discard blower collar by removing (8) screws.
See Fig. 14.
10. Reorient the blower assembly 180 degrees with blower
"belly" down and slide back into the cabinet. See Fig. 15.
11. Reinstall bracket in the new vertical position using (2)
screws. See Fig. 16,
12. Reinstall bracket removed in step 3 using (3) screws in the
same location. See Fig. 17.
.... / [
ii!liiiiiiiiiii
©
Fig. 12 - Retaining Bracket Removal
Fig. 13 - Blower Assembly Removal
A14042
A14043
Fig. 15 - Reinsert Blower Assembly
....
A14045
A14046
Fig. 16 - Reinstall Bracket
A14047
Fig. 17 - Reinstall Bracket Removed in Step 3
Fig. 14 - Blower Collar Removal
©
A14044