Sears GT Series Installation Instructions Manual page 35

IIIIIIIIIIIhlllllllllllllllllllllllllllllllllll .............................................................................................................................................................................................................................................
IIIIIIIIIh,,,,, ........ _ ..........................................
S'I_I_ _IUI_
YELLOW"ALERT"
FLASH CODE 3
YELLOW"ALERT"
FLASH CODE4
YELLOW"ALERT"
FLASH CODE 5
YELLOW"ALERT"
FLASH CODE 6
YELLOW"ALERT"
FLASHCODE 7
YELLOW"ALERT"
FLASHCODE 8
Short Cycling
Compressor is
running only briefly
Locked Rotor
Open Circuit
Open Start Circuit
Current only in run
circuit
Open Run Circuit
Currentonlyln start
circuit
Welded Contactor
Compressor always
runs
Low Voltage
Control circuit <
17VAC
YELLOW "ALERT"
FLASHCODE 9
]. Thermostat demand signal IS intermittent
2. Time delay relay or control board defective
3. If high pressure switch present go to Flash Code 2
information
4. If low pressure switch present go to Flash Code ]
information
1. Run capacitor has failed (may not be bad, verify)
2. Low line voltage (contact utility if voltage at disconnect
is low)
Check wiring connections
3. Excessive liquid refrigerant in compressor
4. Compressor bearings are seized
Measure compressor oil level
]. Outdoor unit power disconnect is open
2. Compressor circuit breaker or fuse(s) is open
3. Compressor contactor has failed open
Check compressor contactor wiring and connectors
Check for cornpressor contactor failure (burned,
pitted or open)
Check wiring and connectors between supply and
compressor
Check for low pilot voltage at compressor contactor
coil
4. High pressure switch is open and requires manual reset
5. Open circuit in compressor supply wlnng or
connections
6. Unusually long compressor protector reset time due to
extreme ambient temperature
7. Compressor windings are damaged
Check compressor motor winding resBtance
1. Run capacitor has failed (may not be bad, verify)
2. Open circuit in compressor start wiring or connections
Check winng and connectors between supply and
the compressor "S'" terminal
3. Compressor start winding is damaged
Check compressor motor winding resistance
1. Open circuit in compressor run wlnng or connections
Check wiring and connectors between supply and
the compressor IIR" terminal
2. Compressor run winding Is damaged
Check compressor motor winding resistance
1. Compressor contactor has failed closed
2. Thermostat demand signal not connected to module
1. Control circuit transformer is overloaded
2. Low line voltage (contact utility if voltage at disconnect
Is low)
Check wiring connections Flash Code number
corresponds to a number of LED flashes, followed
by a pause and then repeated. TRIP and ALERT LEDs
flashing at same time means control circuit voltage
is too low for
operation
35