Sears GT Series Installation Instructions Manual page 17

12. Reinstall blower motor and inlet ring assembly by reversing
Step 6. See Fig. 54.
13. Reconnect blower motor electrical plug and ground wire.
14. Reinstall diagonal bracket(s). See Fig. 55.
Condensate Drain Connection Re-Configuration
When re-configuring the unit from Left-Hand Return to
Right-Hand Return, it is necessary to relocate condensate drain
connection from FRONT left corner post to BACK left corner
post. See Fig. 56.
A14088
Fig. 54 - Reinstall Blower and Inlet Ring Assembly
i_ ! i i{¸
A14089
Fig. 55 - Reinstall Diagonal Bracket(s)
A14090
Fig. 56 - Relocate Condensate Drain Connection
(front left corner to back left corner)
1. Cut the condensate drain hose on the inside of the cabinet.
NOTE: Be sure to retain the spring.
2. Remove and retain condensate drain plastic fitting and
grommet from the hose by pulling it away from the hose
(barb style connection). See Fig. 57.
3. Locate the BACK left condensate drain and remove and
retain plastic plug covering the cutout, See Fig. 58.
Fig. 57 - Relocate Condensate Drain Connection
\\\,_\\
\\\\
A14091
__ 1_
A14092
Fig. 58 - Relocate Condensate Drain Connection
17