Smart Start Led Indicators - Sears GT Series Installation Instructions Manual

SMART START ASSIST LED INDICATORS
Min. recovery time between starts and/or recov- Auto reset when minimum recovery tie
Fully ON 1 11/12
ery time between stop to start elapses.
2 flashes 11/14 Underfoltage &Ue < 190VAC)**** Auto reset with 5 min. recovery**
3 flashes 11/14 Overcurrent (>80A for _>1 sec.) Auto reset with 5 min. recovery
4 flashes 11/14 Relay protection Auto reset with 5 min. recovery***
5 flashes 11/14 Incomplete ramp Auto reset with 5 min. recovery
N/A 11/12 Supply phase loss Physical check
N/A 11/12 Idle state
N/A 11/12 Ramping state
N/A 11/12 Bypass mode
Flashing 11/12 Power supply alarm Replace Smart Start device
Fully ON 11/12 Idle state RSBS waiting for control signal to start
Notes:
1
Applicable to RSBS2332A2V.2C24HP For other models, no indication on the Red LED is provided
Applies only to RSBS23XXA2V22C24 models
Monitored during idle and bypass
Refer to note 6 in Mode of Operation section in Smart Assist Installation Instruction.
Refer to voltage dips and interruptions section in Smart Assist Installation Instruction for mode of operation.
43