Sears GT Series Installation Instructions Manual page 18

4.Reinstall
the removed plastic plugs in the original Conden-
sate Drain Location.
5. Route the flexible plastic tube from FRONT left corner post
to BACK left. See Fig. 59.
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Avoid kinking the hose and/or creating a dip which could
act as a second internal p-trap. Double trapped drain lines
will not drain properly.
6. Measure and cut the condensate drain hose to the
appropriate length.
7. Insert spring onto condensate drain hose.
8. Reinstall condensate drain plastic fitting and bushing in its
new location. See Fig. 60.
HRP Switch Relocation
The HRP Pump Disconnect Switch is mounted on front right
corner post. See Fig. 61.
)
Fig. 61 - HRP Pump Disconnect Switch Location
PERSONAL INJURY AND/OR UNIT DAMAGE
HAZARD
A14094
A14093
Fig. 59 - Route Plastic Tube from Front Left to Back Left
Fig. 60 - Relocate Condensate Drain Connection
A14091
Failure to follow this caution may result in personal iniury
and/or wire damage.
Do not route wiring over potentially hot surfaces or
exposed sharp edges.
m
\
\ )
Fig. 62 - Rectangular Knockout Location
A14095
18