Sears GT Series Installation Instructions Manual page 7

Left-Hand Unit (GT024-72H*L) Instructions:
1. Remove and retain end and side panels. See Fig. 6.
2. Disconnect blower motor wiring and ground wire fastened
to blower housing. See Fig. 7.
3. Remove and retain bracket by removing (3) screws. See
Fig. 8.
4. Loosen blower assembly by removing (4) screws. See Fig.
9.
5. Remove and retain bracket by removing (2) screws. See
Fig. 10.
6. Rotate the blower into its new position. See Fig. 11.
Fig. 6 - Side Panel Removal
A14036
A14037
Fig. 7 - Blower Motor Wring & Ground Wire Location
Fig. 9 - Screws Holding Blower Assembly
Fig. 10 - Screws Holding Blower Bracket
A14039
A14040
_)))))))i
Fig. 11 - Rotate Blower Into New Position
A14041
Fig. 8 - Screws Holding Bracket
A14038