Sears GT Series Installation Instructions Manual page 14

2. Remove and retain Condensing Section access panels
(bottom panel) by removing (3) screws. See Fig. 40.
3. Remove and retain Air Handler Panel by lifting up and out
as shown in Fig. 41. Remove panel about 12" away from
the cabinet and unplug LCD screen wiring. See Fig. 42.
i iii_
i_il iii
A14072
Fig. 40 - Remove Condensing Section Access Panels
1)uP
A14074
Fig. 41 - Remove Air Handler Panel
Blower Re-Configuration
NOTE: This instruction details re-configuration of blower from
UP to SIDE discharge. Reconfiguration to other side uses similar
steps.
1. Remove and retain diagonal support brackets on front and
back sides of the unit. See Fig. 43.
2. Unplug electrical connections of Blower motor and ground
wire connected to blower housing. See Fig. 44.
3. Remove and retain blower motor and inlet ring assembly by
removing (3) bolts securing blower motor bracket and
screws securing the blower inlet ring. See Fig. 45.
NOTE: Removing the blower motor and blower wheel greatly
simplifies handling of the blower assembly and reduces the chance
of damaging heat pump components.
{
i
{
{
J
J
{
{
i
A14076
Fig. 44 - Unplug Electrical Connections and Ground Wire
Fig. 42 - Unplug LCD Screen Wiring
4. Repeat steps 1 - 3 for all three sides.
A14073
14
A14077
Fig. 45 - Remove Blower Motor and Inlet Ring Assembly