Sears GT Series Installation Instructions Manual page 15

4.Remove screws onboth sides o f
the blower securing verti-
cal blower bracket to horizontal support. See Fig. 46.
5. Remove and retain blower assembly by lifting up. See Fig.
47.
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Air coil is in close proximity to the blower. Air coil fins are
easily damaged. Great care must be taken during this step
to avoid coil damage. Shipping cardboard can be used as
protection during blower removal and installation.
6. Remove and discard blower collar. See Fig. 48.
NOTE: Discharge air configuration change is not possible on Heat
Pumps equipped with Electric Heat Option.
7. Remove and retain (2) horizontal blower support brackets
by removing (4) screws in each. See Fig. 49.
NOTE: Upper bracket contains two push-in rubber bump stops.
i
A14078
Fig. 46 - Remove Screws Securing Vertical Blower Bracket
A14080
Fig. 48 - Remove Blower Collar
A14083
Fig. 49 - Remove Horizontal Blower Support Brackets
i
i
]
i
S
i
S
i
S
]
Fig. 47 - Remove Blower Assembly
A14079
15