Sears GT Series Installation Instructions Manual page 16

8. Reinstall brackets removed in Step (9) on the same side of
the unit as the blower outlet. See Fig. 50.
NOTE: Ensure bracket with push-in rubber bump stops is
installed in the top position.
9. Remove and retain vertical brackets from blower by
removing (4) screws, (2) on each side of the blower. See
Fig. 51.
10. Reinstall vertical brackets in new orientation. See Fig. 52.
11. Reinstall the blower assembly in the new desired location,
using the existing holes. See Fig. 53.
[]NIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Be aware of blower housing proxinfity to air side coil and
potential for coil damage.
i ili!il
!iii:lii_ii ¸
;ii!il!ii!il
!i!i_liiii
i _!@!!ii!ii!i!i/i
;]Ii iili;ii iiI!il
111
]] w
I
li! l!l
li!
Fig. 50 - Reinstall Brackets
A14084
A14085
Fig. 51 - Remove
Vertical Brackets from Blower
A14086
Fig. 52 - Reinstall Vertical Brackets in New Orientation
iii i
Fig. 53 - Reinstall Blower Assembly in New Location
A14087
16