Operating Environment; Installation Instructions - inbody BSM170 User Manual

B. Operating Environment
Please make sure that the environment is adequate for the BSM170/170B installation. This equipment is designed
for indoor use. If installing outdoors, the following requirements must be fulfilled.
ON NOTE DANGER
Warning
참 고 주 의
Before installing BSM170/170B, check that the ceiling is at least 2.3 m high. The maximum height of this
•
equipment is 2.19m. Keep a space of at least 3cm between the ceiling and the top of the BSM170/170B.
C. Installation Instructions
1. After opening the BSM170/170B box, remove the packaging materials and take all product components out.
ON NOTE DANGER
Warning
참 고 주 의
Keep the packaging materials provided for repacking the equipment in the future. Other wastes should be
•
disposed of according to relevant laws and regulations.
Install the BSM170/170B on a leveled, non-vibrating surface. Installing the equipment on an uneven surface may
•
cause the examinee to fall down. Measurement results may also be inaccurate.
Never clean the BSM170/170B with liquid spray or detergent directly. The equipment may corrode and/or
•
malfunction if the liquid or detergent leaks inside. Additionally, BSM170/170B measurement tape may be damaged.
When cleaning the BSM170/170B, gently wipe it with the cloth.
2. Insert the "Stand (lower)" into the footplate, ensuring that the arrow ( ▼ ) located on the bottom right of
the "Stand (lower)" and the arrow ( ▲ ) located on the footplate face one another.
* When inserting into the "Stand (lower)", part without screw holes must face downward.
* The "Stand (lower)" and the footplate are designed to be assembled together in only one particular direction. Forcing the stand to
be inserted in other directions could damage the product.
Temperatures range
Relative humidity
Atmospheric pressure
참 조 주 의
참 조 주 의
10 ~ 40℃ (50 ~ 104℉)
30 ~ 75% RH
70 ~ 106kPa
5