Generator - Stihl MS 341 Shop Manual

14.7

Generator

– Remove the ignition module –
b 7.1.2
– Remove the flywheel – b 7.1.5
: Remove the wire from the guide
(arrow).
: Push back the insulating tube (1)
and separate the pin and socket
connector.
1
2
: Take the wire out of the guide
(arrow).
: Take out the screws (1).
: Remove the generator (2).
96
1
: Check generator and poles
(arrow) for cracks or other
damage. If damage is found,
replace the generator.
: Check magnet ring (arrow) in
flywheel for cracks or other
damage. If damage is found,
replace the flywheel.
Install in the reverse sequence.
2
: Place generator in position with
connecting wire (1) facing the
crankcase.
: Position the generator wire at the
bottom of the recess (arrow).
– Install screws (2) with Loctite 242
– b 16.
: Tighten down the screws (2)
firmly – b 3.5
Assemble all other parts in the
reverse sequence.
MS 341, MS 361, MS 361 C
1