Throttle Trigger / Throttle Trigger Interlock - Stihl MS 441 Manual

2
– Lift contact spring (1).
: Push switch shaft (2) into the
bearing guides (arrows) until it
engages.
2
– Contact spring (1) must engage
the guide of the switch shaft (2).
: Contact must be made between
short circuit wire and contact
spring (arrow) in switch position
"$".
– Install filter base, b 14.1.2.
– Install wiring to heating element
in machines with handle heating,
b 15.1.
– Check correct operation.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5.
MS 441, MS 441 C
12.2 Throttle trigger / throttle
trigger interlock
1
– Remove spacer flange,
b 14.2.
: Push pegs (arrows) apart and
through the tank housing.
1
1
: Remove handle moulding (1).
The trigger interlock (arrow) may
pop out.
1
: Remove throttle trigger
interlock (1).
The drag lever is located in the
throttle trigger and must therefore
also be removed.
: Drive pins (arrows) out with
a punch.
1 2
: Lift and turn throttle trigger (1)
with lever (2).
1
: Disconnect throttle cable (1).
– Remove throttle trigger and lever.
85