Connecting To The Rs232; Installation Of The Communications Card (Optional) - MGE UPS Systems Comet EXtreme Series Installation And User Manual

2.6 Connection to the RS232
1. Connect the RS232 communications cable "2" to the serial port on the computer.
2. Connect the RS232 communications cable "2" to the RS 232 communications port "1" on the UPS.
The UPS can now communicate with all MGE UPS SYSTEMS supervision, set-up or safety software.
Figure 2-11: RS232 Connection. Pin-out diagram for the RS232 communications port 1 on the UPS.
2.7

Installation of the Communications Card (Optional)

It is not necessary to shut down the UPS to install the communications card:
1. Remove the slot cover "3" .
2. Insert the card in the slot.
3. Secure the card with the two screws.
Figure 2-12: Communications Card Slots.
Connections
Installation and User Manual
page 2 — 9