Install Pneumatic Joint, Xe-Axis Assembly And Drive Belt - Creality ENDER-3 V2 User Manual

3. Install Pneumatic Joint, XE-axis Assembly and Drive Belt

X-axis
XE-axis
8
12
Profile x 1
Assembly x 1
Hexagon Socket
Flat Round Head
Bowden Tube
23
32
Connector x 2
Spring Washer
Combination
Wrenches and
17
Drive Belt x 1
25
Screwdrivers x 1
17
12
23
● Tighten the Bowden tube connector firmly into the Extruder using an open-end wrench.
● Align the bolt head on the XE-Axis Assembly into the hole on the X Axis profile.
● Secure the XE-axis Assembly to the X-Axis Profile with two M4X16 screws. (Insert the
Allen key through the holes on the outer plate).
● Install the Drive belt round the pulley inside the XE-axis Assembly with the toothed side
round the pulley as shown above.
Install the drive belt
around the pulley.
8
25
32
11