The Reset Button - ZyXEL Communications LTE Series User Manual

To activate WPS (WiFi must be already on):
You can also quickly set up a secure wireless connection between the Zyxel Device and a WPS-
compatible client by adding one device at a time.
Press the WiFi or WiFi/WPS button for more than 1 second but less than 5 seconds and release it (pressing
1
more than 5 seconds will turn off WiFi).
Press the WPS button on another WPS-enabled device within range of the Zyxel Device.
2
For LTE3301-PLUS:
Once a wireless connection is ready, the WLAN LED turns green/white.
For LTE7240-M403:
Once a wireless connection is ready, the WLAN LED shines green.
For LTE7461-M602 / LTE7480-M804 / LTE7480-S905 / LTE7490-M904:
Once a wireless connection is ready, the LED blinks amber.
To turn off the wireless network:
Press the WiFi or WiFi/WPS button for more than 5 seconds.
For LTE3301-PLUS:
The WLAN LED turns off when the wireless network is off.
For LTE7240-M403:
The WLAN LED turns off when the wireless network is off.
For LTE7461-M602 / LTE7480-M804 / LTE7480-S905 / LTE7490-M904:
The amber LED turns off.

1.5.4 The RESET Button

If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button of the Zyxel Device as shown in the following figure to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously saved. The password will be
reset to the default (see the Zyxel Device label) and the IP address will be reset to 192.168.1.1.
Figure 12 Reset Button (LTE3301-PLUS)
Chapter 1 Introduction
LTE Series User's Guide
23