No Security - ZyXEL Communications LTE Series User Manual

The following table describes the general wireless LAN labels in this screen.
Table 22 Network Setting > Wireless > General
LABEL
WiFi Network Setup
Band
WiFi
Channel
Bandwidth
Control
Sideband
WiFi Network Settings
WiFi Network
Name
Max Clients
Hide SSID
Multicast
Forwarding
BSSID
Security Level
Security Mode
Cancel
Apply

6.2.1 No Security

Select No Security to allow wireless stations to communicate with the access points without any data
encryption or authentication.
Chapter 6 Wireless
DESCRIPTION
This shows the WiFi band which this radio profile is using. 2.4GHz is the frequency used by IEEE
802.11b/g/n WiFi clients while 5GHz is used by IEEE 802.11a/ac WiFi clients.
Click Enable to enable the wireless LAN in this field.
Use Auto to have the Zyxel Device automatically determine a channel to use.
Select whether the Zyxel Device uses a
A standard 20MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz channel
uses two standard channels and offers speeds of up to 300Mbps.
40MHz (channel bonding or dual channel) bonds two adjacent radio channels to increase
throughput. The WiFi clients must also support 40MHz. It is often better to use the 20MHz setting in
a location where the environment hinders the
Select 20MHz if you want to lessen radio interference with other
WiFi
neighborhood or the clients do not support channel bonding.
This is available for some regions when you select a specific channel and set the Bandwidth field
to 40MHz. Set whether the control channel (set in the Channel field) should be in the Lower or
Upper range of channel bands.
The SSID (Service Set IDentity) identifies the service set with which a
WiFi
devices associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for the wireless LAN.
Specify the maximum number of clients that can connect to this network at the same time.
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot obtain
the SSID through scanning using a site survey tool.
This check box is grayed out if the WPS function is enabled in the Network > Wireless > WPS
screen.
Select this check box to allow the Zyxel Device to convert wireless multicast traffic into wireless
unicast traffic.
This shows the MAC address of the wireless interface on the Zyxel Device when wireless LAN is
enabled.
Select More Secure (WPA2-PSK) to add security on this
to associate to this network must have the same
you select to use a security, additional options appears in this screen.
Or you can select No Security to allow any client to associate with this network without any data
encryption or authentication.
See the following sections for more details about this field.
Click Cancel to restore your previously saved settings.
Click Apply to save your changes.
LTE Series User's Guide
WiFi
channel width of 20MHz, 40MHz or 20/40MHz.
WiFi
signal.
WiFi
WiFi
security settings as the Zyxel Device. When
64
WiFi
devices in your
WiFi
device is associated.
WiFi
network. The clients which want