Scan And Slew Rate; Viewing On The Display Monitor - FLIR SeaFLIR II Series Operator's Manual

Commercial in Confidence
Export Level 2
Issued to: AgustaWestland
operator in the lower left area of the display. After selecting the SCAN
width, operator repeats "SHIFT" function to store selection.
3.11.1

SCAN and Slew Rate

The SCAN speed control sets the scan speed for the Auto-Scan mode.
Rotate the SCAN speed control down to slow the scan speed or up to
increase the scan speed.
3.12

Viewing on the Display Monitor

Depending on how long the system has been operating, it
may take up to ten minutes for an IR image to appear on the
display after switching the HCU Power Switch to the ON
position and selecting the IR camera.
Several pieces of information are presented on the display to aid the
operator.
mode, GPS data, azimuth and elevation indicators as well as focus and
zoom when in use.
Valid on Day of Issue only.
Document will not be updated
Figure 3-37. Auto-Scan Field of Regard
Operating information including Date and time, operating
CM Ref:4049
NOTE:
61
Uncontrolled : 4256
Retrieval Date:07-Dec-10
Requested by Bower, Richard