Perform Final Tests - Magtek ExpressCard 2000 Preventive Maintenance Procedure

4 - Perform Final Tests

4 Perform Final Tests
After completing preventive maintenance, follow these steps to test the device and restore it to its original
state:
1) Re-connect the power and network cables.
2) Re-attach any security hardware.
3) Re-install consumables.
4) Close all open doors.
5) Power up the device.
6) Re-synchronize the image printer ribbon.
7) Create a sample card using customer card stock.
8) Check image print quality and embosser alignment, and adjust components as necessary.
9) Fill out the checklist included with the preventive maintenance kit, and return it and the tipper heater
to MagTek.
Ensure any unused materials from the kit are personally handed off to a branch
representative – most importantly, any used or unused print ribbons or embossing foils.
ExpressCard 2000| Instant Issuance Card Personalization System | Preventive Maintenance Procedure
Page 25 of 25 (D99875651-25)