Service The Hopper Module - Magtek ExpressCard 2000 Preventive Maintenance Procedure
Instant issuance card personalization system
Hide thumbs
Also See for ExpressCard 2000:
- Hardware service manual (356 pages) ,
- User's installation and operation manual (84 pages) ,
- Manual (42 pages)
Table of Contents
Advertisement
3 - Preventive Maintenance Procedure
3.6
Service the Hopper Module
Follow these steps to service the hopper transport:
1) Use the
MCP Commands
to verify the movement is smooth and there is no belt slippage.
2) Only if the hopper transport rods are dirty, wipe off the dirt with a soft, lint-free cloth.
3) Check the hopper transport drive belt for signs of damage. If it is damaged, contact MagTek Support
Services for a replacement.
ExpressCard 2000| Instant Issuance Card Personalization System | Preventive Maintenance Procedure
page to move the hopper transport from the front to the rear of the device
Page 13 of 25 (D99875651-25)
Advertisement
Table of Contents
Need help?
Do you have a question about the ExpressCard 2000 and is the answer not in the manual?