Clean The Card Cleaning Roller - Magtek ExpressCard 2000 Preventive Maintenance Procedure

3 - Preventive Maintenance Procedure

3.10 Clean the Card Cleaning Roller

Clean the card cleaning roller by following these steps:
1) Remove any jewelry or accessories that could touch the print head during cleaning.
2) Open the image printer.
3) Remove the cleaning roller (see Figure 3-8).
4) Unwrap the roller wipe from the kit and rub it gently over the entire surface of the roller. Pay special
attention to spots that feel uneven, which may be dirt or dust stuck to the roller. If there are any
uneven or rough spots you can not wipe off, contact MagTek Support Services for assistance.
5) When the card cleaning roller has dried, re-install it into the image printer.
ExpressCard 2000| Instant Issuance Card Personalization System | Preventive Maintenance Procedure
Figure 3-8 - Removing the Card Cleaning Roller
Page 18 of 25 (D99875651-25)