Programming And Adjustments - Nice E EDGE SI 620 AC ZW Instructions And Warnings For Installation And Use

4

PROGRAMMING AND ADJUSTMENTS

4.1 - Groups of programming and adjustment pro-
cedures
There are 5 groups of programming and adjustment procedures:
Group A – done with a
Z-Wave gateway.
Group B – done with a
dedicated programmer.
4.2 - Positions in which the awning stops automati-
cally
The electronic system that controls the awning movement at all times can automati-
cally stop the motor when the awning reaches a certain position (or "height"). UP
and DOWN must be programmed by the installer. The positions are shown in fig. 4
as follows:
– position "0" = UP limit (awning completely retracted);
– position "1" = DOWN limit (awning completely extended);
– position "H" = INTERMEDIATE position (awning partially open)
4
Procedures which can only be complet-
ed using a Z-Wave gateway.
Programming with a programmer or
other compatible accessory (for in-
stance: TTPRO).
English – 6