Nice E EDGE SI 620 AC ZW Instructions And Warnings For Installation And Use page 8

A.1 - Adding the device to the Z-Wave network
A
NOTES AND WARNINGS
• If the adding process is unsuccessful, perform the removing procedure (A.2), then repeat the adding procedure again.
A.1.1 - Adding manually
1
ON
Connect the electrical pow- Set the Z-Wave gateway in-
er supply to the motor. to adding mode (see the Z-
Wave gateway's manual).
4
DSK: XXXXX-XXXXX-XXXXX-XXXXX
XXXXX-XXXXX-XXXXX-XXXXX
Only If you are adding in the Security S2
Authenticated mode: input the underlined
part of the DSK (label on the box)
A.1.2 - Adding using SmartStart
SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present on the product with a gateway providing SmartStart in-
clusion. SmartStart product will be added automatically within 10 minutes of being switched on in the network range.
1
If your Z-Wave gateway supports
SmartStart, set it into Security S2 Au-
thenticated add mode (see the Z-Wave
gateway's manual).
5
...
Wait ... If adding is successful: the light turns solid green for 3 seconds;
If adding is unsuccessful: the light turns solid red for 3 seconds,
then starts flashing green slowly.
7 – English 7 – English
–– GROUP "A" PROCEDURES ––
Procedures which can only be completed using a Z-Wave gateway
2 3
On the motor head: press and release ei-
ther of the two buttons (3 times);
5
...
Wait ...
2
DSK: XXXXX-XXXXX-XXXXX-XXXXX
XXXXX-XXXXX-XXXXX-XXXXX
Enter the full DSK string code to your Z-
Wave gateway. If your controller is capable
of QR scanning, scan the QR code (label on
the box).
(x 3)
If adding is successful: the light turns solid green for 3 seconds;
If adding is unsuccessful: the light turns solid red for 3 seconds,
then starts flashing green slowly.
3
ON
Connect the electrical pow-
er supply to the motor.
end
 4
the green led starts flashing quickly.
end
4
The green led starts flashing quickly,
when the adding process starts.
 5