First Power Up - Nice E EDGE SI 620 AC ZW Instructions And Warnings For Installation And Use

i
3
For eventual extraction of the connector
3
ELECTRICAL CONNECTIONS AND

FIRST POWER UP

The motor has two separate cables: the power cable and the control cable. Each
cable has a connector for connection to the motor (fig. 3-h); the connectors are re-
movable and allow the possible replacement of cables (fig. 3-i). CAUTION! - The
smaller cables must be handled carefully because they contain very thin wires
that could be damaged.
CABLE "A" is the POWER cable (fig. 2)
Wire Colour
A1 Brown
A2 Blue
A3 Yellow-green
CABLE "B" is the CONTROL cable (fig. 2)
Wire Colour
B1 White
B2 White-orange
B3 White-black
CAUTION! – DO NOT connect any wires from cable "B" to the power line.
1
2
3
Connection
Power supply phase
Neutral
Earth
Connection
Voltage free contact for the Up command
Not used
Common
l
CAUTION! - The smaller cables must be handled carefully because they
contain very thin wires that could be damaged.
3.1 - Connection of motor to electricity mains
The motor is powered by a permanent connection to the mains. Use cable "A" (fig.
2) for this connection, making sure to observe the warnings in full.
3.2 - Connecting pushbutton panels
You can connect either 1 or 2 button panels.
Caution! - The maximum length of the cables used to connect a wall-mounted pan-
el or a relay is 100 m.
– Model with 1 button excites an input: the command is Step-by-step. The panel
must be connected to the white and white-black wires.
3.3 - Connecting accessories
OFF
• Cabled accessories: use cable "B" referring to fig. 3 and the following instruc-
tions.
– You can connect only one compatible accessory at a time to the white and
white-black cables.
– You can connect only one compatible accessory at a time to the white-black ca-
ble.
– Up to 5 tubular motors can be connected to one accessory, respecting the polarity
OFF
of the signals (connect the white-black cables of all motors together).