Day And Night Mode; Switching Between Day And Night Mode - Bosch FPA‑5000 User Manual

72 en | Day and night mode
17

Day and night mode

This chapter contains information about the following points:
–
–
The manner in which an incoming alarm is handled depends on whether the system is in day
or night mode; see Fire alarm, page 40 .
Caution!
Night mode is the highest security level as every incoming alarm is forwarded to external
!
stations.
Notice!
Depending on the security level in question, not all detectors can be switched to day mode.
The following symbols on the status bar show which mode the panel is switched to. In the
case of networked panels, a night-/day combination icon is displayed on panels in night mode,
if at least one panel in the network is in day mode.
Notice!
Please note that following a transmission fault it may be necessary to synchronize the day/
night mode of the other panels manually in order for the current mode to be displayed
correctly.
17.1

Switching between day and night mode

Notice!
Depending on the programming, the panel automatically switches from day to night mode at
the preset time.
There are two ways to switch between day and night mode:
–
–
Switching over via the menu
Depending on the mode to which the panel is switched, Switch to day mode or Switch to
night mode is displayed in the start menu.
1.
2020-07 | 3.0 | F.01U.378.877
Switching between day and night mode
Changing the time for resetting to night mode
Night mode
Day mode
Night-/day
combination
Switching over via the menu
Switching via the status bar
The panel is in night mode: Select Switch to day mode to switch to day mode:
Standalone
Panel is in night mode All networked panels in the
Panel is in day mode
-
User Guide
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Network
network scope are in night mode
-
Panel is in night mode but at least
one other panel in the network
scope is in daymode
Bosch Sicherheitssysteme GmbH