Bosch FPA‑5000 User Manual page 62

62 en | Diagnostics
2.
To display information on an available Plena voice alarm system:
Touch one of the systems displayed in order to select it. The following information is
displayed:
–
–
–
–
–
–
–
–
To display information on an available VAS over IP:
Touch the voice alarm system displayed in order to select it. The following information is
displayed:
–
–
–
–
–
–
–
To check the availability of the VAS over IP in the network, choose Send ping command to
send a ping request to the VAS over IP IP address.
2020-07 | 3.0 | F.01U.378.877
VAS
A list of the available voice alarm systems is displayed.
Trouble (yes/no)
Emergency (yes/no)
Failure (yes/no)
Internal monitoring (yes/no)
Supervision time (sec).
Boot-up phase is finished (yes/no)
Failure at controller (yes/no)
Failure at router (yes/no)
Connection status: Shows whether an IP connection to the VAS over IP exists.
Status of VAS over IP: In case of trouble please check the VAS over IP.
Trigger configuration:
Mismatch: A VAS Virtual Trigger programmed in the AVENAR panel 8000/2000
configuration cannot be matched to an equivalent trigger on the VAS over IP side. Please
check the mapping of the virtual VAS triggers/virtual control inputs configured in the
FSP-5000-RPS programming software and the VAS over IP configuration.
Compatibility: Shows whether the version of the connected VAS over IP is released for
the connection to an AVENAR panel 8000/2000. If a warning is displayed please check the
version of the VAS over IP.
Connection fault counter: Shows the number of connection errors to the VAS over IP
until the last reboot of the panel.
Address of VAS over IP: IP address of the VAS over IP.
Port of VAS over IP: VAS over IP port number. The default value is 9401.
User Guide
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Bosch Sicherheitssysteme GmbH