Error Code List - Topcon RD-80SA Instruction Manual

4.5 Error Code List

Error cord obtained via [ERR] command and their details are as below.
Code Details
E0000 Normal
E0001 System Error
E0015
E0016
E0017
E0018
E0002 Error in internal memory
E0003
E0004 Failure of Photo detector calibration
E0005
E0006 Receive parameter is abnormal
Countermeasure
Please contact your dealer or Topcon Technohouse
Advice us of the error code, the circumstance when the problem
happen in details.
If momentary interruption of power, let us know it also.
Internal memory error happen
Restart the instrument. If the instrument does not recover from the
error, Please contact your dealer or Topcon Technohouse. Advice us
of the error code, the circumstance when the problem happen in details.
If momentary interruption of power, let us know it also.
Please contact your dealer or Topcon Technohouse.
Advise us of the error code, the circumstance when the problem
happen, and following points;
－Error happen again after press [CALIB] switch ?
－Error happen during measurement ?
－Measurement data is correct ?
Check following points
- Parameter in sending is specified within valid value range?
- The number of parameter is correct?
Message on display
system error
range system error
filter system error
sensor system error
motor system error
memory init error
memory access error
calibration error
calculation error
parameter error
57