Xantrex Freedom XC PRO Series Owner's Manual page 9

HAZARD OF ELECTRIC SHOCK, EXPLOSION, BURN, OR
ARC FLASH
Apply appropriate personal protective equipment (PPE) and
l
follow safe electrical work practices. See NFPA 70E or CSA
Z462.
This equipment must only be installed and serviced by
l
qualified electrical personnel.
Never operate energized with the wiring compartment cover
l
removed.
Energized from multiple sources. Before removing the wiring
l
compartment cover - identify all sources, de-energize, and
wait 2 minutes for circuits to discharge.
Always use a properly rated voltage sensing device to
l
confirm all circuits are de-energized.
Replace all devices, doors, and covers before turning on
l
power to this equipment.
Failure to follow these instructions will result in death or serious
injury.
975-0799-01-01
DANGER
ELECTRICAL SHOCK HAZARD
Replace the wiring compartment cover before turning on
l
power to this equipment.
Use a torque screwdriver to tighten the captive nut panel
l
screw to 5 in-lb torque to ensure a proper ground connection
and a required tool access to the wiring compartment.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
FIRE AND EXPLOSION HAZARD
Unit's components may produce arcs or sparks.
l
Do not install near batteries, in machinery space, or in an
l
area in which ignition-protected equipment is required.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
Areas include any space containing gasoline-powered machinery,
fuel tanks, as well as joints, fittings, or other connections between
components of the fuel system.
Product Safety Information
WARNING
WARNING
ix