Xantrex Freedom XC PRO Series Owner's Manual page 48

Basic Installation Procedures
GFCI Connections
1. Remove the GFCI cover plate by removing the four screws
holding it in place.
2. Set the four screws aside.
3. Install the GFCI kit according to its wiring diagram shown on
the device. See Ground Fault Circuit Interrupters (GFCIs) on
page 21 for information on compatibility.
4. Secure the GFCI device to the wiring panel using the four
screws set aside earlier.
5. Prepare a 4" (100 mm) black AC wire (for line) and connect
one end to the AC OUT L terminal.
6. Splice three black Line wires together using a twist-on wire
connector: the other end of the black AC wire (in step 6), the
AC Output Line wire, and one end of the 15 A breaker wire.
7. Connect the other end of the 15 A breaker wire to the GFCI's
L terminal.
8. Prepare a 4" (100 mm) white AC wire (for neutral) and
connect one end to the GFCI's N terminal.
9. Prepare a 4" (100 mm) white AC wire (for neutral) and
connect one end to the AC OUT N terminal.
10. Splice three white Neutral wires together using a twist-on
wire connector: the other end of the white AC wire (in step
9), the other end of the white AC wire (in step 10), and the
AC Output Neutral wire.
11. Prepare a 4" (100 mm) green/bare AC wire (for ground) and
connect one end to the GFCI's G terminal.
12. Prepare a 4" (100- mm) green/bare AC wire (for ground) and
connect one end to the AC OUT G terminal.
32
13. Splice three green/bare ground wires together using a twist-
on wire connector: the other end of the green/bare AC wire
(in step 12), the other end of the green/bare AC wire (in step
13), and the AC Output Ground wire.
14. Return to Step 10 on page 31.
Freedom XC PRO Owner's Guide