Xantrex Freedom XC PRO Series Owner's Manual page 102

Troubleshooting Reference
Problem
No output voltage is shown in the LCD
screen but the green status LED for
Battery mode is illuminated.
No output voltage is shown in the LCD
screen and neither of the green status
LEDs (for Grid mode and Battery mode)
is illuminated.
No output voltage. The status LED is
not lighting up.
86
Possible Cause
GFCI (when installed) has tripped
or supplementary breaker has
tripped.
Circuit breaker on the AC load
panel or AC output disconnect has
tripped.
Battery voltage is too low
(depending on setting, see
Freedom XC PRO Unit on page
78) to start inverting. LCD screen
may show DC voltage as 000.
AC shore power is not available or
out of operating range and the
inverter/charger is OFF.
AC shore power is not available
and the inverter/charger is OFF
due to a shutdown for more than
30 seconds.
Ignition lock (ACC) signal is not
present.
Solution
Check load and reset the GFCI or supplementary
breaker.
Reset the circuit breaker or check the AC output
disconnect circuits.
Check DC connections and cable.
Recharge battery.
Check AC shore power.
Turn the inverter/charger ON.
Check AC shore power and battery voltage.
Turn the inverter/charger ON and look at the LCD
screen for any error code.
See "Problem" on the previous page.
If the ignition control feature is in use, ensure the
vehicle's ignition is On and the ignition control switch on
the front of the Freedom XC PRO unit is On (|).
Freedom XC PRO Owner's Guide