Xantrex Freedom XC PRO Series Owner's Manual page 55

Figure 15 20-pin Communications Harness Pinouts
975-0799-01-01
1 (yellow) CAN_L
2 (grey) ACC_INPUT
3 (black)
4 (orange)
5 (black)
6 (black)
7 (violet)
8 (white/red)
9 (white/blue)
10 (blue)
20 (grey)
19 (brown)
18 (grey)
17 (white)
16 (grey)
15 (white/violet)
14 (red)
13 (black)
12 (white/green) CAN_Shield
11 (white/black) CAN_H
Figure 16 20-pin CCPort Pinouts
Blue - not used
White/blue - not used
White/red - not used
Violet - not used
Black - not used
Black - not used
Orange - not used
Black - not used
Grey - ACC_INPUT
Yellow - CAN_L
Connecting to ACC Signal
With the 20-pin Communications Harness (PN: 808-0820), the
Freedom XC PRO can be wired to inhibit inverter operation in the
absence of a vehicle's (or vessel's) +12VDC ignition control
signal. This feature can avoid unnecessary battery drain that
would otherwise occur if the inverter/charger was operated
without a charging source such as the vehicle alternator.
To enable ignition control:
1. Ensure that AC and DC power are both OFF.
2. Ensure the vehicle's ignition is turned to OFF position. It is
highly recommended to remove battery power by
disconnecting the vehicle's battery cables. Refer to the
Basic Installation Procedures
Grey - not used
Brown - not used
Grey - not used
White - not used
Grey - not used
White/violet - not used
Red - not used
Black - not used
White/green - CAN_Shield
White/black - CAN_H
39