Jumper Settings; Clear Cmos Jumper; Table 5-1: Jumpers - Global American 3307800 User Manual

out and push the rear of the SO-DIMM down. (See Figure 5-5)
Step 5: Secure the SO-DIMM. Release the arms on the SO-DIMM socket. They clip into
place and secure the SO-DIMM in the

5.5 Jumper Settings

NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
Before the 3307800 is installed in the system, the jumpers must be set in accordance with
the desired configuration. The jumpers on the 3307800 are listed in Table 5-1.
Description
Clear CMOS

Table 5-1: Jumpers

5.5.1 Clear CMOS Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Page 82
socket.Step 0:
Label Type
J_CMOS1
J_CMOS1
3-pin header
See Table 5-2
Jumper
3-pin header
3307800