3307800
shown in Chapter 3.
Step 2:
Insert the connector. Connect the IDE cable connector to the onboard
connector. See Figure 5-7. A key on the front of the cable connector ensures it
can only be inserted in one direction.
Figure 5-7: IDE Cable Connection
Step 3:
Connect the cable to an IDE device. Connect the two connectors on the other
side of the cable to one or two IDE devices. Make sure that pin 1 on the cable
corresponds to pin 1 on the connectorStep 0:
5.7.3 Audio Kit Installation
An optional audio kit that is separately ordered connects to the 9-pin audio connector on
the 3307800. The audio kit consists of five audio jacks. One audio jack, Mic In, connects to
a microphone. The remaining four audio jacks, Front-In, Front-Out, Rear-Out and
subwoofer connect to four speakers including a subwoofer. To install the audio kit, please
refer to the steps below:
Page 87