Dual Rs-232 Cable Connection; Figure 5-9: Fdd Cable Connection - Global American 3307800 User Manual

3307800
Step 2: Insert the connector. Connect the FDD cable connector to the on-board
connector. See Figure 5-9. A key on the front of the cable connector ensures it
can only be inserted in one direction.

Figure 5-9: FDD Cable Connection

Step 3: Connect the cable to an FDD device. Connect the connector at the other end
of the cable to an FDD device. Make sure that pin 1 on the cable corresponds to
pin 1 on the connector.

5.7.5 Dual RS-232 Cable Connection

The dual RS-232 cable consists of two connectors attached to two independent cables.
Each cable is then attached to a D-sub 9 male connector that is mounted onto a bracket. To
install the dual RS-232 cable, please follow the steps below.
Step 1: Locate the connectors. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 0:
Page 89