Set The Carrier Address Id - Avaya S8700 Installing Manual

Installing the Avaya™ S8700 Media Server with Avaya™ G600 Media Gateway
Perform these tasks to install the Avaya G600 port network:
• ''Set the Carrier Address ID'' on page 69
''Mount the Avaya G600 Media Gateway in the Rack'' on page 70
•
''Cabling the G600 Media Gateways'' on page 82
•
Front view of Avaya G600 Media Gateway
Figure notes
ESD Ground Jack
1
2 650A Power Supply
TN2312AP IP Server Interface
3
Circuit Pack

Set the Carrier Address ID

Set the Carrier Address ID either before or after installing each media gateway.
1 Loosen the thumb screws on the fan assembly and pull it straight out as shown in
assembly removal'' on page
installed in the rack.
Verify and, if necessary, set the carrier address ID for each media gateway as shown in
2
''Setting media gateway carrier address ID'' on page
gateway in the A location, "B" settings are for the media gateway in the B location, "C"
settings are for the media gateway in the C location, and "D" settings are for the media
gateway in the D location. "E" settings are not used in this configuration.
3 4
1
2
1 2 3 4 5 6
Power
4
5
6
7
70. Leave the fan assembly off until the unit is completely
May 2003
5
6
7
7 8 9 10
scdlff01 LJK 031102
TN799DP C-LAN (optional)
TN2302 IP Media Processor
Accessory compartment
Cable pass-through (if needed)
70. "A" settings are for the media
69
''Fan