Cabling 3 Media Gateways; Cabling 4 Media Gateways - Avaya S8700 Installing Manual

Installing the Avaya™ S8700 Media Server with Avaya™ G600 Media Gateway

Cabling 3 Media Gateways

1 Remove the bottom panel and fan assembly from media gateway C.
If not already removed, remove the fan assembly from media gateway B.
2
Remove the left TDM/LAN bus terminator from media gateway B, and install it at the
3
right end of the TDM/LAN bus in media gateway C.
Remove the nuts on the posts of the plates covering the bottom left TDM/LAN cable
4
routing slot of media gateway C and the top left TDM/LAN cable routing slot of media
gateway B. See ''TDM/LAN bus cable routing slot plate removal'' on page 85
5 Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in
both media gateways. Push the free end of the EMI Gasket back in place. See
''TDM/LAN bus cable routed through the media gateway'' on page
6 Install the lower terminator of the TDM/LAN bus cable on the left end of TDM/LAN bus
in media gateway B. Make sure the arrows on the back of the cable terminators point
upward.
Install the upper terminator of the TDM/LAN bus cable on the left end of the TDM/LAN
7
bus in media gateway C.
8 Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the
ends of the routing slots are covered.
9 If finished, reinstall the fan assemblies and bottom panel. Otherwise continue cabling
media gateway D.

Cabling 4 Media Gateways

1 Remove the bottom panel and fan assembly from media gateway D.
If not already removed, remove the fan assembly from media gateway C.
2
3 Remove the right TDM/LAN bus terminator from media gateway C, and install it at the
left end of the TDM/LAN bus in media gateway D.
Remove the nuts on the posts of the plates covering the bottom right TDM/LAN cable
4
routing slot of media gateway D and the top right TDM/LAN cable routing slot of media
gateway C. See ''TDM/LAN bus cable routing slot plate removal'' on page
5 Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in
both media gateways. Push the free end of the EMI Gasket back in place. See
''TDM/LAN bus cable routed through the media gateway'' on page
Install the lower terminator of the TDM/LAN bus cable on right end of TDM/LAN bus
6
in media gateway C. Make sure the arrows on the back of the cable terminators point
upward.
7 Install the upper terminator of the TDM/LAN bus cable on the right end of the
TDM/LAN bus in media gateway D.
Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the
8
ends of the routing slots are covered.
Reinstall the fan assemblies and bottom panel on each media gateway.
9
May 2003
87
86.
85.
86.