KYMCO G-Dink 125i Manual page 281

7. Steering > Removal G-Dink 125i
Steering Stem Removal
SAFETY FIRST: Protective gloves and eyewear are recommended
at this point.
Support the vehicle with a suitable stand or jack so that the front wheel
is off the ground. Grip the bottom of the fork legs and turn the front end
side-to-side. If the movement is rough the bearings should be greased
or replaced. If the movement is to tight or loose the steering stem
adjusting nut may need to be adjusted.
The KYMCO G-Dink 125i uses ball bearings in the steering. Always
replace the races at the same time as the bearings.
Remove the handlebar covers. See the Handlebar Covers topic for more
information.
Remove the front cover. See the Front Cover topic for more information.
Remove the handlebar. See the Handlebar topic for more information.
Remove the front fender. See the Front Fender topic for more
information.
Remove the front wheel. See the Front Wheel topic for more
information.
Remove the front fork. See the Front Fork topic for more information.
2