Table of Contents
Advertisement
Refitting the appliance door
Follow the instructions in the reverse order to refit the
appliance door.
When fitting the appliance door, ensure that both
1.
hinges are inserted straight into the opening (fig.
Slide the appliance door down as far as it will go.
Open the appliance door fully. Close the two locking
2.
levers (fig.
).
"
Close the cooking compartment door.
3.
Fitting and removing the glass panels
To facilitate cleaning, you can remove the glass panels
from the appliance door. If required, for example if the
appliance is installed higher up, you can remove the
entire door and lay it on a flat surface.
Locking the appliance door
Open the appliance door fully.
1.
Open the two locking levers on the left and right
2.
(fig.
).
!
Close the appliance door as far as it goes (fig.
3.
Removing panels
Press on the left- and right-hand sides of the cover
1.
(fig.°
).
!
Remove the cover (fig.
2.
).
"
Lift out the inner panel (fig.
3.
carefully on a flat surface.
).
!
Take off the seal on both sides and remove it
4.
(fig.
).
$
Lift out the intermediate glass panel (fig.
5.
it down carefully on a flat surface.
).
"
If necessary, you can remove the condensate trough
6.
for cleaning. To do this, open the appliance door
fully (fig.
Tilt the condensate trough up and remove it (fig.
7.
Clean the panels with glass cleaner and a soft cloth.
Wipe the condensate trough with a cloth and some hot
soapy water.
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
■
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
Risk of injury!
Appliance door
) and set it down
#
).
&
en
) and set
%
).
'
31
Advertisement
Table of Contents
