Table of Contents
Advertisement
Appliance door
en
Fitting and removing the glass panels
To facilitate cleaning, you can remove the glass panels
from the appliance door. If required, for example if the
appliance is installed higher up, you can remove the
entire door and lay it on a flat surface.
Locking the appliance door
Open the appliance door fully.
1.
Open the two locking levers on the left and right
2.
(fig.
).
!
Close the appliance door as far as it goes (fig.
3.
Removing panels
Press on the left- and right-hand sides of the cover
1.
(fig.°
).
!
Remove the cover (fig.
2.
Lift out the inner panel (fig.
3.
carefully on a flat surface.
32
).
"
) and set it down
#
Take off the seal on both sides and remove it
4.
(fig.
).
$
).
"
Lift out the intermediate glass panel (fig.
5.
it down carefully on a flat surface.
If necessary, you can remove the condensate trough
6.
for cleaning. To do this, open the appliance door
fully (fig.
Tilt the condensate trough up and remove it (fig.
7.
Clean the panels with glass cleaner and a soft cloth.
Wipe the condensate trough with a cloth and some hot
soapy water.
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
■
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
The hinges on the appliance door move when
Risk of injury!
■
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Components inside the appliance door may have
Risk of injury!
■
sharp edges. Wear protective gloves.
).
&
) and set
%
).
'
Advertisement
Table of Contents
