Table of Contents
Advertisement
Zone
Cleaning products
Oven carriage base
Hot water with a little soap or water and
vinegar:
Clean with a dishcloth.
Glass cover for the
Hot water and a little soap:
oven light
Clean with a dishcloth.
Seal (do not remove) Hot water and a little soap:
Clean with a dishcloth. Do not rub.
Accessories
Hot water and a little soap:
Soak and clean using a dishcloth or
brush.
Cleaning the self cleaning surfaces in the oven interior
The inside rear and side walls and top of some ovens may be
lined with a highly porous ceramic lining. This lining absorbs
splashes produced during baking and roasting, dissolving them
while the oven is working. This cleaning will be most effective at
higher temperatures and during longer cooking times.
Proceed as follows if the oven is still dirty after being used
several times:
Thoroughly clean the bottom and any walls that do not have
1.
this lining.
Programming the 3D
:
2.
Empty the oven and then leave it on with the door closed for
3.
approximately 2 hours at maximum temperature.
The ceramic lining will regenerate. Once the oven has cooled
down, remove any brown and white stains with water and a soft
sponge.
Slight discolouration of the lining does not affect its self-
cleaning performance.
Caution!
Do not use abrasive cleaning products. These would scratch
■
and impair the highly porous lining.
Never use oven cleaning products on ceramics. If oven
■
cleaner is spilled on this accidentally, immediately remove it
using lots of water and a sponge.
Cleaning the oven's enamelled bottom and walls
Use a cleaning cloth and hot water with a little soap or vinegar.
If very dirty, use a fine steel scourer or a special oven cleaning
product. These must only be used when the oven interior is
cold. Do not use metal scourers or special oven cleaning
products on self-cleaning surfaces.
Light
The oven light can be turned on manually to facilitate cleaning.
Turning on the oven light
Turn the function control knob to the
The light will come on. The temperature control knob must be
turned off.
Turning the oven light off
Turn the function control knob to the
10
hot air function.
setting.
\
Û
position.
Removing the grill heating element
The grill heating element can be removed in some ovens to
facilitate cleaning.
:
Risk of burns.!
The oven must be cold.
Pull the grill element handle towards you and push it upwards
1.
until you hear it click into position (figure A).
At the same time, hold the grill element and swing it down
2.
(figure B).
$
After cleaning, push the grill heating element up again. Push
the locking handle down and secure the grill element.
Removing the oven carriage
The oven carriage can be easily removed to make cleaning the
oven easier. Pull out the oven carriage its full limit. Hold the
carriage on both sides, lift it slightly and remove it. Place it
carefully on a flat surface. The base of the oven contains
delicate components.
After cleaning, the oven door can be refitted by repeating the
procedure in reverse.
Fitting and removing the glass panels
To make cleaning easier, the glass from the oven carriage can
be removed.
Dismantling
Removing the oven carriage.
1.
Remove the top cover of the oven carriage. To do this,
2.
unscrew the right and left-hand side screws (figure A).
Hold the glass in your hands (left and right) and remove
3.
upwards (figure B).
Place these on a cloth with the handle facing downwards.
The inside glass with the hooks should not be removed from
the oven carriage.
$
%
%
Advertisement
Table of Contents
