Installation To Extension Column - PEERLESS PSMU-PRS Installation And Assembly Manual

Installation to Threaded Rod
3
Attach projector mount assembly (A) to two 3/8-16 threaded rods (not included) using two 3/8-16 hex thin nylon-
insert locknuts (not included) as shown in figure 1.1 or figure 1.2.
Skip to step 4.
3/8 -16 THREADED ROD
(NOT INCLUDED)
A
3/8 -16 HEX THIN
NYLON-INSERT
LOCKNUT
(NOT INCLUDED)

Installation to Extension Column

3
Screw projector mount assembly (A) onto extension column (sold separately) as shown in figure 2.1. Note: For
3/4" extension columns, reducer ACC 913 will be required as shown in figure 2.2. Tighten swivel stop screw
against extension column or reducer using 4 mm allen wrench (S). Note: Swivel stop screw is used to jam
against threads of extension column or reducer to prevent any excess movement of projector mount assembly
(A). Do not overtighten screw; overtightening screw will damage threads making it difficult to separate products.
Skip to step 4.
A
SWIVEL STOP SCREW
FRONT OF
MOUNT
fig. 1.1
1 1/2" EXTENSION
COLUMN
BACK OF
MOUNT
SWIVEL STOP SCREW
3/8 -16 THREADED ROD
(NOT INCLUDED)
A
3/8 -16 HEX THIN
NYLON-INSERT
LOCKNUT
(NOT INCLUDED)
A
FRONT OF
MOUNT
fig. 1.2
3/4" EXTENSION COLUMN
ACC 913
BACK OF
MOUNT