Advertisement
4
Open the mount and remove thumb screw as
shown.
Note: The upper tray of the mount will now slide
off of the lower tray.
Installation of Projector
5
Flip projector upside down. Attach lower tray to
the bottom of the projector using appropriate
number of screws (K,L,M,N,O,P,Q,R,S) , washers
(I) and spacers (F) as shown. Use 4 mm allen
wrench (S) to tighten screws.
Important: If projector does not have at least
three mounting holes, do not use this tray
assembly.
Note: Some projectors have feet which can be
removed and the corresponding threaded insert
can be used for a mounting hole.
Note: Projector may differ slightly in appearance.
WARNING
• Do not overtighten! Overtightening may cause perma-
nent damage to the projector. Torque to 26-35 in • lb (30-
40 kg • cm).
THUMB
SCREW
SPACER
SCREW
WASHER
LOWER
TRAY
Advertisement
