Advertisement
Installation To Wood Joist Finished Ceilings,
Exposed Wood Joists, or Wood Beam Ceilings
3
Drill two 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach projector mount assembly (A) with
two #14 x 2.5" (6 mm x 65 mm) wood screws (V) and two flat washers (I) as shown in figure 1 or figure 2
depending on joist orientation. Tighten wood screws (V) using 3/8" (10 mm) socket wrench until projector mount
assembly (A) is firmly attached.
Note: Be sure to drill holes into the joist CENTER!
Skip to step 4.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can damage screws, greatly reducing
their holding power. Tighten to 80 in • lb (9 N.M.)
maximum torque.
WOOD JOIST
A
FRONT OF
MOUNT
I
V
figure 1
WARNING
A
I
V
figure 2
WOOD JOIST
FRONT OF
MOUNT
Advertisement
