Advertisement
Option 1 - Installation to Single Wood Stud Wall
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is
highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of mounting situations (Not evaluated by UL).
Using wall plate (L) as a template, drill four 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach wall
3
plate (L) to centers of wood studs using four #14 x 2.5" wood screws (E) shown in figure 3.1.
Fasten wall bracket (A) loosely to wall plate (L) using four M5 x 8 mm pan head screws (F), and #10 washers (K).
DIAMOND INDICATES
TOP OF WALL PLATE
E
L
fig 3.1
WARNING
F
5 of 11
L
A
K
ISSUED: 08-17-09 SHEET #: 090-9186-4 02-09-10
fig 3.2
Advertisement
