Advertisement
Installation to Extension Column
1
Thread tray assembly (A) into cord management (B) to extension column (sold separately) as shown.
Note: Slotted set screw (X) is used to jam against threads of extension column to prevent any excess movement
of projector mount assembly (A).
Skip to step 2
WARNING
• Do not overtighten! Overtightening may cause
permanent damage to the projector. Torque to
26-35 in • lb (30-40 kg • cm).
2
Remove the lock plug (S) by using key to unscrew it from the assembly as shown in detail 2.1. Open the
mount and remove thumb screw as shown in detail 2.2.
Note: The upper tray of the mount will now slide off of the lower tray.
S
DETAIL 2.1
1 1/2" EXTENSION
COLUMN
(SOLD SEPARATELY)
UL LISTED EXT OR
ADJ SERIES)
B
A
THUMB
SCREW
DETAIL 2.2
Advertisement
