AMP Research PowerStep 76332-01A Installation Manual page 6

A M P R E S E A R C H P O W E R S T E P
Remove fuse from wire harness
4
Attach wire harness to
controller (make sure
connector locking tabs
fully engage). Mount
controller with the two
11" tie wraps to factory
conduit, just forward of
battery.
4
Route factory harness underneath vehicle and
plug in motors (both sides). Route remaining
LED light wires back towards rear of vehicle.
6
Remove grommet
in floor panel
above front
linkage on driver
side. Poke small
hole into grommet
and thread the
two trigger wires
through and up
into the cabin
of vehicle. Seal
grommet with
silicone sealer.
16 8
10
www.amp-research.com
– F O R D E X P E D I T I O N
T M
Connect red and black power leads to battery
accessory studs. Red lead goes to positive.
Route shorter leg of harness down passenger-
side wheel well and longer leg of harness down
along driver side wheel well. Secure with tie
wraps.
5
Remove driver side front kick panel and door
sill plate. Roll back carpet to access hole for
passing trigger wires into cab of vehicle.
7
POKE SMALL HOLE
THROUGH GROMMET
6/9
IM76332 rev 08.02.19