Daily Care And Maintenance; Thorough Cleaning - Toto Washlet S400 SW563 Instruction Manual

Thorough Cleaning of the Product
Cleaning the Washlet main unit, the toilet seat and lid
● The toilet lid and seat can be removed, so the every surface of the unit can be cleaned.
Removing the toilet seat and lid
Open the toilet seat and lid and
raise the seat lock (grey) until you
hear a "click."
Take hold of the toilet seat and
lid at the base.
Align the toilet lid with the top
side of the seat sensor window
(black).
Pull straight up on the toilet
seat and lid with both hands.
✲ The toilet seat cord can only be pulled
approximately 2 inches (5 cm). Please do not
use excessive force when pulling. (It could
cause a broken electrical connection.)
✲ Please do not pull up at an angle or use
excessive force. (Otherwise damage could
result.)
Place the toilet seat/lid on the
toilet as shown in the diagram.
Clean the main unit as well as the
toilet seat and lid.
Please clean within the guidelines offered under
"Daily Care and Maintenance" on page 25.
26
The toilet lid can be removed from the toilet seat.
[Removing the lid]
1 Place your finger on the seat lock on
the right side and move the hinge
module toward the inside
(approximately 2 inches (5 mm)).
2 Remove the toilet lid from the toilet
seat.
❈ The seat lock and hinge module
cannot be removed from the toilet
seat.
Attaching the toilet seat/lid
Check that the toilet seat pins
are pointing up and down.
❈
When these are not pointing up and down,
please press the button and ten
seconds later press the button.
Check that the seat lock (grey)
is raised.
❈
If the seat lock is not raised all the way up,
it won't be possible to attach the toilet
seat/lid.
Align the toilet seat and lid with the top
side of the seat sensor window (black)
and push firmly onto the toilet seat pins
❈
Please attach the unit so that the blue line
of the toilet seat cord does not get twisted.
❈
Pressing into place at
an angle can cause
damage.
Lower the seat lock (grey) firmly until you
hear a "click."
❈
If the seat lock won't go down, the toilet seat/lid
are not attached.
Please reattach the toilet seat and lid again.
[Reattaching the lid]
Align the toilet lid with the
1
toilet seat from the left.
2 Move the hinge module on
the right toward the outside.
27