Before Using The Washlet - Toto Washlet S400 SW563 Instruction Manual

Before Using the Washlet

Preparation
Putting batteries in the remote control.
➀
Remove the remote control from the hanger.
Holding both side of the remote control, lift it straight
upwards.
➁
Open the battery cover on the back of the remote
control.
➂
Insert two AA batteries.
➃
Close the battery cover.
When the batteries are set correctly in place, the
remote control display module will look like the picture
at right.
Batteries
In order to keep batteries from splitting or leaking, please be sure to observe the following.
●
Use new batteries of the same type for replacements.
●
Remove the batteries when not using the unit for long periods of time.
● Do not use rechargeable batteries.
● When replacing the batteries or cleaning the unit, please turn the power on/off button on the
1
main unit controls to "off." Otherwise, if you mistakenly press a button, the Washlet will flush the
toilet, or open/close the toilet seat or lid.
● When replacing the batteries, the on/off settings for the timer power saver and auto functions
could be lost. (Example: even when the auto toilet flush is set to "off," it is "on.")
Please reconfigure the settings.
12
®
1
Remote Control Display
Insert the plug into the wall
outlet.
2
Opening the water shut-off valve
and the junction valve.
Please turn on the junction valve with a
flathead screwdriver.
Check
Check the "Main unit display".
Are the "POWER" LED and the "SEAT" LED
on the main unit display lit?
3
If the "POWER" LED is not lit, then it
won't be possible to use all of the
functions. Please press the power
on/off button on the main unit control.
(The LEDs will go on.)
The first time that the toilet lid opens after the power cord is plugged in, it will stop if it runs into any
2
obstacles and the next time that the toilet lid opens, it may stop opening (or close) after opening
part way. (It stores the position from the first time it opens.)
Unplug the power cord when there are no obstacles and then plug it back in and press the [See
source for graphic.] button on the remote control.
3
Please refer to "Adjusting the temperature" on Page 16 concerning turning the toilet seat "on" or
"off" or adjusting the temperature.
13