To Conserve Energy; Saving Power With The Timer - Toto Washlet S400 SW563 Instruction Manual

While standing in front of the toilet
Someone must stand in front of the toilet for
at least six seconds for the automatic flush
to work.
After urinating, move at least
1 ft. (30 cm) away from the
toilet.
After approximately three seconds, the
toilet will flush automatically.
● When the sensor no longer detects
anyone, the "SENSOR" LED on the main
unit display will turn off.
✲ When the auto flush or remote control flush is operating, please do not push the toilet manual flush lever the
opposite direction. It could damage the manual flush lever on the toilet.
To turn off the auto toilet flush
Press the buttons on the
remote control
Turns off auto toilet flush
● "FLUSH" will disappear from the remote control display.
● Please follow the same procedure to turn it on again.
1
When small children use the Washlet, the sensor may not detect them due to their location in
front of the toilet or their height. In such cases, please flush the toilet with the remote control
buttons.
The automatic flush will not work for approximately 60 seconds after an automatic flush. Please
use the button on the remote control.
2
During power outages or when the batteries wear out, please flush the toilet by hand using the
toilet tank lever.
20
1

To Conserve Energy

Saving power with the timer energy saver
The timer energy saver...
Once the settings are configured, power
saving will take place every day at that time.
During timer power saving, the toilet seat
heater will be off.
The power saving times can be set to 3, 6 or
9 hours.
■ For example, to save power from 1:00 to
7:00 am (six hours).
Example: When saving power from 1:00 am until 7:00 am (six hours)
1 Press the button on the
remote control at the time
you want to begin saving
energy (1:00 am)
Energy saving will begin.
The words "TIMER" and "SAVING TIME: 3 hrs."
will be displayed on the remote display module.
2
Press the button and
set six hours.
During timer power saving, the "ENERGY SAVER"
LED (green) on the main unit display turns on.
Changing the energy saving
period
Press the button.
● Each time the button is pressed, the display will
change from 3 to 6 to 9 to off (no display).
Please select the desired time.
✲ When you want to change the energy saving period (3, 6 or 9 hours), please reconfigure the starting time settings.
3 The Washlet can still be used, even while saving power. If someone sits on the toilet seat during
the energy-saving period, the toilet seat heater will turn on temporarily. It takes approximately 15
minutes for the toilet seat to heat up.
4
When you want to change the power saving start time, please shut off the timer energy saving
feature and press the button once more to set the desired starting time.
3
4
21