Flushing The Toilet - Toto Washlet S400 SW563 Instruction Manual

When sitting on the toilet seat
Move at least 1 ft. (30 cm)
from the toilet after using the
toilet.
After approximately 90 seconds, the
toilet lid will close automatically.
● When the sensor no longer detects
anyone, the "SENSOR" LED on the main
unit display will turn off.
When standing in front of the toilet.
● Please open the toilet seat using the remote
control.
Move at least 1 ft. (30 cm)
from the toilet after using the
toilet.
After approximately 90 seconds, the toilet
lid and seat will close automatically.
● When the sensor no longer detects
anyone, the "SENSOR" LED on the main
unit display will turn off.
To turn off the auto open/close
Press the buttons on the
remote control.
Turns off auto open/close
● "OPEN/CLOSE" will disappear from the remote control display .
● Please follow the same procedure to turn it on again.
Person detection sensor
● The person detection sensor senses when a person is standing in front of
the toilet.
● The person detection sensor emits infrared light as shown in the diagram.
A person will be detected when a he or she approaches in the direction of
this infrared beam.
18

Flushing the toilet

There are two ways to flush the toilet: Remote control flushing and Auto flushing .
Flushing the toilet using remote control
The toilet can be flushed using the large flush button on the remote control.
Press button
on the remote control.
The toilet will flush.
Flushing the toilet using auto flushing
The toilet will flush automatically when you move away from the toilet.
When sitting on the toilet seat
The automatic flush feature will not work unless
you remain seated for at least six seconds.
Stand up after using the toilet.
The toilet will flush automatically
after approximately five seconds.
✲ Depending upon the manner of sitting or posture, the sensor may not detect correctly and cause the toilet to flush
automatically even when someone is still seated on the toilet.
✲ When the auto flush or remote control flush is operating, please do not push the manual toilet flush lever the
opposite direction. It could damage the manual flush lever.
1 The toilet flush switch cannot be used continuously. Please wait approximately ten seconds before
flushing again.
2
Initially, the Washlet is set for automatic toilet flushing.
When small children are to use the toilet, the sensor may not flush automatically because it
couldn't sense them properly.
The automatic flush will not work for approximately 60 seconds after an automatic flush. Please
use the button on the remote control.
2
1
19