Toto Washlet S400 SW563 Instruction Manual page 19

Round/elongated type
Table of Contents

Advertisement

Rear cleansing/front cleansing
Problem
Possible Cause
The
,
and
automatically after around five minutes.
The cleansing water
turned off early.
Is the seat sensor working properly?
When the seat sensor functions, it runs the
After sitting on the
water to prepare to spray warm water.
toilet seat, water
Additionally, changing position while seated can
flows into the toilet
cause the seat sensor to turn on or off, causing
from around the wand
water to flow for several seconds from around
for several seconds.
the wand. It is not malfunctioning.
Heated toilet seat
Problem
Possible Cause
The toilet seat
Is the toilet seat temperature set to "off" or
"low?"
doesn't get warm
Is the unit in timer power saving?
Is the unit on auto power saveing?
About one hour after sitting on the toilet seat, the
The toilet seat is cold
toilet seat heater will shut off. If you move away
from the toilet, the toilet seat heater will turn on
again automatically.
Dryer
Problem
Possible Cause
The dryer temperature
Is the dryer temperature set to "low?"
is low
The dryer stops automatically about 10 minutes
after pressing the
Is the seat sensor working properly?
Is the seatsensor working properly?
The dryer doesn't
work at all
36
Solution
buttons turn off
Please press the
,
button again. Page 14
Please read the section about the
seated sensor. Page 41
Solution
Please make adjustments using the
buttons on the remote control.
Page 16
After sitting on the toilet seat, the
heater turns on and warms up in about
15 minutes. Page 21
After sitting on the toilet seat, it will
warm up temporarily.
Solution
Please make adjustments using the
buttons on the remote control.
Page 16
Please press the
button again.
Page 15
button.
Please read the section about the seat
sensor. Page 41
Please read the section about the seat
sensor. Page 41
Deodorizer
Problem
or
The deodorizer
doesn't work
It sometimes doesn't
remove much odor
Deodorizer starts on
its own
Energy-saving function
Problem
The Auto energy
saving does not work
even after the button
is pushed
Page 22.
The energy savers
don't start at the
correct time.
Energy saving does
not occur
Possible Cause
Is the seat sensor working properly?
Is the deodorizer filter blocked?
Under the following circumstances, the seat
sensor may function, triggering the deodorizer. It
is not malfunctioning.
● When standing in front of the Washlet.
● During cleaning
● When the toilet tank lever is operated, etc.
Possible Cause
It takes two or three days to determine the time
periods when the toilet is not used very often.
When the same time period is used about three
times a week, the power saving will not work
during that time period. It is not malfunctioning.
Is the power cord unplugged or has there been a
power outage?
Did you replace the batteries in the remote
control, unplug the power cord was or have a
power outage? (If so, the time settings may be
incorrect.)
Did you replace the batteries in the remote
control?
(The settings may have been reset.)
Solution
Please read the section about the
seated sensor. Page 41
● Please clean the deodorizer filter.
Page 29
● If odor is still a problem even after
cleaning the deodorizer filter, call
TOTO technical support.
Solution
It may not function properly that day,
but it should be functioning properly by
the next day.
Please press the Timer on/off button or
the Auto on/off button on the remote
control and reconfigure the settings.
Gradually, it will save power during the
correct times. Pages 21 to 23
Please press the Timer on/off button or
the Auto on/off button on the remote
control and reconfigure the settings.
Pages 21 to 23
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Washlet s400 sw564

Table of Contents